Air Source Heat Pump Locations: Indoor & Outdoor Placement

Air source heat pumps (ASHPs) consist of an outdoor unit (compressor/heat exchanger) and one or more indoor units (air handlers). Proper placement is critical for efficiency, noise control, and longevity.

Typical Locations

Outdoor Unit

  • Ground-mounted: On a concrete pad or mounting brackets at grade level—most common for houses.
  • Wall-mounted: On brackets attached to exterior wall—saves space, good for townhomes.
  • Roof-mounted: On flat commercial roofs or structurally reinforced residential roofs—requires crane access and vibration isolation.

Indoor Unit(s)

  • Basement / utility room: Central ducted systems (air handler + coil).
  • Wall-mounted heads: Ductless mini-splits in each zone (bedrooms, living areas).
  • Ceiling cassettes: Recessed in drop ceilings (commercial/retrofit).
  • Floor-mounted consoles: Low-wall units for radiant-style heat.

Placement Factors

  • Climate: Cold climates need defrost clearance; snowy areas require elevated mounting.
  • Airflow: Minimum 12–24" clearance around outdoor unit; no obstructions.
  • Noise: Place outdoor unit away from bedrooms/neighbors; use vibration pads.
  • Refrigerant line length: Keep runs within manufacturer limits (typically ≤50–150 ft).
  • Drainage: Outdoor unit must drain condensate; indoor units need condensate pumps or gravity drains.
  • Aesthetics/access: Balance visibility with service access.

Professional Sizing and Installation Are Mandatory

Incorrect placement reduces COP (efficiency), increases wear, and voids warranties. Always use a certified HVAC contractor (NATE, ACCA) for load calculation (Manual J) and installation.

Heat Stroke - Related Articles